10 2 10 3 10 4 10 5 -140 -130 -120 -110 -100 -90 -80 -70 pca0163 a telecommunications satellite telemetry 3 21 163.84 -70 1.0 -10 4 n/a -40 to 85 frequency range rms phase error (100 hz - 100 khz) harmonic suppression (2nd, typ.) sideband spurs (typ.) switching speed (typ., adjacent channel) startup lock time (typ.) operating temperature range package style cpll mhz dbc dbc msec msec c vdc ma supply voltage (vcc, nom.) supply current (icc, typ.) all specifications are typical unless otherwise noted and subject to change without notice. phase noise (1 hz bw, typical) low cost - high performance ? z-communications, inc. all rights reserved page 1 phase locked loop features applications performance specifications value units power supply requirements application notes 163.84 mhz step size: 80 khz - style package cpll a1 rev an-107 : how to solder z-comm vcos / plls an-200 : mounting and grounding of z-comm plls an-201 : pll fundamentals an-202 : pll functional description notes: reference oscillator signal: 5 mhz< f osc <100 mhz fre q uenc y s y nthesizer: analo g devices - adf4001 9939 via pasar san diego, ca 92126 tel (858) 621-2700 fax (858) 621-2722 power output 02 dbm load impedance 50 step size 80 khz 1250 163.84 - frequency range: - 163.84 ? charge pump output current ?
low cost - high performance phase locked loop ? z-communications, inc. page 2 printed in the u.s.a. pca0163 a power curve, typ. page 2 physical dimensions side view bottom view 2 1 12 3 4 5 6 7 8 9 10 11 top view p1 rf output p2 reference oscillator input p3 clock p4 data p5 load enable p6 lock detect p7 vcc p8 ground p9 no connection p10-12 ground 1. the inside radius of all 14 half holes at the perimeter of the board are plated to provide a surface for the attachment of the pll module to the motherboard. 5 pads are for grounding, 8 pads are for signal interface. 2. the surface of the shield is tin-plated and may be soldered to. the shield's base metal is brass. 3.the ground plane on the bottom side is ground and attaches to a ground track on the top side of the board as well as to the shield. 4. unless otherwise noted all dimensions are in inches. 5.unless otherwise noted all tolerances are as follows: .xxx = .010 c 25 pll output spectrum frequency offset (khz) power
|